Option Parts Eagle Racing R31 Suspension Mounts (1)

Published on May 14th, 2012 | by Drift Mission

7

Eagle Racing R31 Suspension Mounts






Eagle Racing R31 Suspension Mounts (1)New Eagle Racing R31 aluminum suspension mounts for the GRT R31 and R31 compatible chassis. The following option parts are made for securing the lower suspension arm hinge pins to the chassis. The suspension mounts also determine the amount of toe adjustment on your chassis. The new aluminum option parts are anodized in gold or blue to match your chassis. The suspension mounts are available from 2.5 degrees and decreasing in 0.5 increments to -3.0 degrees. These parts are good for increasing the rigidity of the suspension mounts for more consistent performance.

Eagle Racing R31 Suspension Mounts (2)
Eagle Racing R31 Suspension Mounts

  • Part No: R31-31/xxLBL and R31-31/xxGO

    • *Note: xx denotes the degrees or the toe block, R31-31/-2.0LBL is -2.0 toe in Blue

  • Available angles: 2.5, 2.0, 1.5, 1.0, 0.5, -0.5, -1.0, -1.5, -2.0, -2.5, -3.0
  • Increase rigidity of lower suspension mounts
  • Made of aluminum
  • Fits Original R31 and Eagle GRT R31

    • Approximate MSRP: ¥650JPY

    Source: Eagle Racing Japan

    Tags: , , , , , , , ,


    About the Author

    RC Drift Specialist for Driftmission.com


    Related Posts



    • krecoun

      Hello, does anyone have these? do they come 2 in set or only the one as shown on the picture? thanks

      • http://driftmission.com/ DriftMission

        Broadtech carries these products.  They come in singles only as shown in the picture with 2 screws :)

    • http://www.facebook.com/cooperxl Pedro Azevedo

      Finally…Anyone knows the stock toe on an R31?

      • http://driftmission.com/ DriftMission

        No idea, the manual is not much help either…

    • http://www.facebook.com/cooperxl Pedro Azevedo

      Well, I think I’ve sorted it out…acording  to the genuine manual, the arm mounts are: Inner Rear “uG -3º” Outer rear “A 0º”

      Inner front ” A 0º” Outer front  “A 0º”

      So..0º toe on front and 3º on the front. 

    • multi-bash

      Pedro is correct. I picked up a -1* and -2* to have a wide set of tuning options. Good fit and looks nice under there. You’ll want two 0* blocks to bling out the ends of the chassis. The inner blocks arn’t very visible.

      • http://driftmission.com/ DriftMission

        thanks for the reply, this will help others also :)

    Back to Top ↑

    © 2013 DriftMission.com - All Rights Reserved



    Back to Top ↑