Weld Overdose RC products has release wide angle universal drive shafts for the RC-Art CE-RX Chassis. Made of high strength materials in a stylish Overdose fashion, these drive shaft will perform as good as they look. An essential upgrade for anyone looking to get more than 50° out of their CE-RX.
The RC-Art CE-RX chassis utilizes the R31 style suspension and steering system. To maximize the performance of the CE-RX chassis, Overdose now provide a 51mm length universal driveshafts. With the Overdose Drive Shafts you can now get up to 55° of steering angle, without any chattering problems.
RC-Art CE-RX Wide-angle Driveshaft
Approximate MSRP: ￥3700JPY
Source: Weld Overdose
any ideas, whether they will fit the ARD CER or not? Should be long enough, however I am worried about the bearing size.
Not 100% sure, OD’s sites do not specify if it will fit on a CER or not…. The bearings used for the CE-RX are 1050 and 1510.
Will the 51mm fit on stndard TEH R31 i though it was 48mm. It is confusing
These specific driveshafts are for RC-Art CE-RX chassis. They will not be compatible with your TEH-R31.
In the image with the angle displayed, the pin isn’t even in the shaft. It looks like it’d get more like 55 degrees.
I mean 50 degrees*
Will the 51mm fit on stndard TEH R31 i though it was 48mm. It is confusing
These specific driveshafts are for RC-Art CE-RX chassis. They will not be compatible with your TEH-R31.
Not 100% sure, OD’s sites do not specify if it will fit on a CER or not…. The bearings used for the CE-RX are 1050 and 1510.
In the image with the angle displayed, the pin isn’t even in the shaft. It looks like it’d get more like 55 degrees.
I mean 50 degrees*
any ideas, whether they will fit the ARD CER or not? Should be long enough, however I am worried about the bearing size.